Efergy Energy metering and monitoring Manuál s instrukcemi stáhnout pdf (Strana 5)

transmission signal

LINKING TRANSMITTER AND DISPLAY

INSTALLATION

Link Button

If the LINK is COMPLETED you

will see the transmission signal

If the LINK is NOT COMPLETED

you will see dashes on the

display

1. Ensure three AA batteries are inserted in the

transmitter and three AA batteries inserted in the display

unit.

2. Press the Link Button on the back of the display unit

and hold for 2 seconds, the transmission signal symbol

and dashes will flash for one minute or until the

transmitter and display are linked.

3. While the transmission signal in the display flashes

push the Learn Button in the transmitter and wait until

the transmission signal symbol becomes solid.

Note: The default value for the transmission frequency

is six seconds. This means the transmitter is sending

information every six seconds. You can change the

frequency from 6s to 12s and to 18s by pushing and

holding the transmitter button for two seconds.

1. Fit The Sensor

The sensor needs to be fitted to the live feed cable. Sensors are suitable for cables up to

12mm in diameter. You should not force the cable to fit. The sensor should fit loosely around

the cable and there should be no packing used.

2. Plug The Sensor Cable Into The Transmitter

Insert the jack on the end of the white wire into any of the three input sockets on the

transmitter. The clip-on sensor acts as a current sensor and relays the current being drawn into

the home to the transmitter.

If your cables are too big for the sensor you can order

XL-sensors at www.efergy.com

1. Push the release cap

to open the sensor.

2. Select the correct feed

cable, then place the feed

cable into the top of the

sensor.

3. Close the sensor.

The sensor is secure

when a “click” is heard.

Learn Button

1 2 3 4 5 6 7 8 9 10

Komentáře k této Příručce

Žádné komentáře

Efergy Energy metering and monitoring Manuál s instrukcemi Strana 5

Komentáře k této Příručce